Küppersbusch EWK178002Z Benutzerinformation Seite 23

Problem
The compressor operates
continually.
DEMO appears on the dis-
play.
The temperature in the wine
cellar is too high.
If the advice does not lead to
the desired result, call the
nearest brand-mark service.
Replacing the lamp Wine Cellar
1. Disconnect the mains plug from the
mains socket.
2. Remove the lamp cover by pressing it
inwards with a tool (e.g. screwdriver) to
free the rear side hookings.
Possible cause
The lamp is defective.
Temperature is set incor-
rectly.
Many food products were
put in at the same time.
The room temperature is
too high.
Food products placed in
the appliance were too
warm.
The door is not closed cor-
rectly.
The appliance is in demon-
stration mode.
There is no cold air circula-
tion in the appliance.
The temperature regulator
is not set correctly.
The door is not closed cor-
rectly.
Many bottles are stored at
the same time.
There is no cold air circula-
tion in the appliance.
3. At the same time, free the middle hook
and slide off the cover in the direction of
the arrows.
Solution
Refer to "Replacing the lamp".
Refer to "Operation" chapter.
Wait some hours and then
check the temperature again.
Refer to climate class chart on
the rating plate.
Allow food products to cool to
room temperature before stor-
ing.
Refer to "Closing the door".
Keep the Mode pressed for ap-
proximately 10 seconds until a
long sound is heard and display
shuts off for a short time.
Make sure that there is cold air
circulation in the appliance.
Set a lower temperature.
Refer to "Closing the door".
Store less bottles at the same
time.
"Make sure that there is cold air
circulation in the appliance.
23