Freezing Fresh Food; Storage Of Frozen Food; Ice-Cube Production - Electrolux ER 7536 I Gebrauchsanweisungen

Freezing fresh food

The 4-star compartment is suitable for
long term storage of commercially frozen food, and
for freezing fresh food.
To freeze fresh foods press the ambient switch at
least 12 hours before introducing the food into the
freezer.
Place the food to be frozen on the bottom
compartment.

Storage of frozen food

When first starting-up or after a period out of use,
before putting the products in the compartment let
the appliance run for at least two hours on the
coldest setting, then turn the thermostat knob to the
normal operating position.
To obtain the best performance from this appliance,
you should:
if large quantities of food are to be stored, remove
all drawers and baskets from appliance and place
food on cooling shelves.
Pay careful attention not to exceed load limit stated
on the side of the upper section (where applicable)
Important
In the event of accidental defrosting, for example
due to a power failure, if the power has been off
for longer that the value shown in the technical
characteristics chart under Òrising timeÓ, the
defrosted food must be consumed quickly or
cooked immediately and then refrozen (after
cooling).
Thawing
Deep-frozen or frozen food, prior to being used, can
be thawed in the refrigerator compartment or at
room temperature, depending on the time available
for this operation.
Small pieces may even be cooked still frozen,
directly from the freezer: in this case, cooking will
take longer.

Ice-cube production

This appliance is equipped with one or more trays
for the production of ice-cubes. Fill these trays with
water, then put them in the freezer compartment.
Do not use metallic instruments to remove the
trays from the freezer.
52
A
D710
A - Ambient switch
With room temperature lower than +16¡C switch (A)
should be depressed (the built-in light will come on).
GerŠt in die Nische einschieben bis die
Anschlagleiste (A) unten am Mšbel anliegt.
TŸr šffnen und GerŠt gegenŸber der Bandseite an
die Mšbelseitenwand anrŸcken. GerŠt mit den 4 bei-
liegenden Schrauben befestigen.
BelŸttungsgitter (C) und Scharnierabdeckung (D)
aufstecken.
Fugenabdeckprofiloben um die Winkeldicke
ausschneiden und zwischen GerŠt und Mšbelseiten-
wand eindrŸcken.
In die Befestigungsund Scharnierlšcher beiliegende
Abdeckkappen (B) eindrŸcken.
Die Teile A, B, C, D abnehmen, wie in der Abb.
gezeigt wird.
A
D023
D
C
D723
D724
B
D726
B
A
C
D
13
PR266