9. Connect Brown wire from the supply circuit (incoming active/phase) to the active
terminal (L).
10. Connect Blue wire (neutral) from the supply circuit to the Neutral terminal (N).
11. The phase (L) and neutral (N) conductors of the supply cable are connected
according to terminal assignment (Figure I).
12. Close the unit by remounting the cover and fix it with the screws.
13. Switch on supply and the detector will commence a 60 seconds warm-up period.
14. Make the desired adjustments (see "Adjustments") and put back the white cover-ring,
turning it clockwise.
Afbeelding H
Note: Power cord specs:
2 x H05RN-F 3C / 2C 1,5mm² max.
2 x H05RR-F 3C / 2C 1,5mm² max.
- 13 -
Afbeelding I