Installation; Connection To The Power Supply - Monacor FO-642LED Bedienungsanleitung

Installation:

Warning: This equipment must be installed only by a qualified electrician. Installation must
follow local building codes as well as the instruction contained in this manual. Turn off power
at circuit breaker or fuse box, to make sure power is off before installation. If you have any
doubts about the installation procedure, please ask a qualified electrician.

Connection to the power supply:

1. Note: This unit must be installed according to local Wiring Regulations and Code of
Practice.
2. Ensure the supply is disconnected at the distribution board before beginning with the
electrical wiring.
3. Note: Make sure that the power wiring comes from an external 10A miniature circuit
breaker for short circuit protection.
4. Study the wiring diagram below before making any electrical connections. Incorrect
wiring of the unit could destroy the unit.
5. Determine the best location for the product. Install the product at least 3 ft. away from
fluorescent and HVAC ducts, and at least 4 ft. away from incandescent fixtures and
HVAC diffusers.
Figure F
6. Remove the cover as shown in figure F.
7. Push the connection cable(s) through the rubber seal in the back panel opening.
8. Mount the unit on the wall as shown in figure G
Figue G
- 12 -