Renlig FWM7D5 Handbuch Seite 28

ENGLISH
Problem Possible cause
Check whether there are any leaks
from one of the inlet hose fittings. It
is not always easy to see this as
the water runs down the hose;
check to see if it is damp.
The drain or inlet hose is dam-
aged.
The filter has not been properly
screwed in after cleaning action.
The washing programme is still
running.
The door will The door lock has not been re-
not open: leased.
There is water in the drum.
The transit bolts and packing have
not been removed.
The appliance The support feet have not been
produces an adjusted
unusual noise:
The drain pump could be blocked.
Too little detergent or unsuitable
detergent has been used.
Stubborn stains have not been
treated prior to washing.
Unsatisfactory
The correct temperature was not
washing results:
selected.
Excessive laundry load.
The drying time or the dryness de-
gree has not been selected.
The machine
The water tap is closed.
does not dry or
does not dry
The drain filter is clogged.
properly:
The machine is overloaded.
Solution
Check the water inlet hose connec-
tion.
Replace it with a new one (check
with the After Sales Service the
right spare part number).
Screw the filter fully in.
Wait the end of washing pro-
gramme.
Wait a few minutes until the door
indicator light goes off.
Select drain or spin programme to
empty out the water.
Check the correct installation of the
appliance.
Check the correct levelling of the
appliance.
Check the drain pump. (See
"Cleaning the pump" for more de-
tails).
Increase the detergent quantity or
use another one.
Use commercial products to treat
the stubborn stains.
Check if you have selected the cor-
rect temperature.
Reduce the laundry load in ac-
cording to the "Washing Pro-
grammes table".
Select the drying time or the dry-
ness degree.
Open the water tap.
Clean the drain filter.
Reduce the laundry load in the
drum.
28