Renlig FWM7D5 Handbuch Seite 27

ENGLISH
Problem Possible cause
An option or a programme that
ends with the water still in the tub
or a that eliminates all the spinning
phases has been selected.
The appliance
door is open or
not closed cor-
rectly.
The plug is not properly inserted in
the power socket.
There is no power at the socket.
The main fuse has blown.
The programme selector dial is not
The appliance
correctly positioned and the button
does not start:
5 has not been pressed.
The delay start has been selected.
The Child Lock function is activa-
ted.
The appliance The mains supply has been cut off.
switches off
during the
washing phase:
The electronic unbalance detection
device has cut in because the laun-
dry is not evenly distributed in the
drum. The laundry is redistributed
The appliance
by reverse rotation of the drum.
spinning phase
This may happen several times be-
starts late or
fore the unbalance disappears
does not start:
and normal spinning can resume.
If, after 10 minutes, the laundry is
still not evenly distributed in the
drum, the appliance will not spin.
Too much detergent or unsuitable
There is water
detergent (creates too much foam)
on the floor:
has been used.
Solution
Select the draining or spinning
programme.
Close the door firmly.
Insert the plug into the power
socket.
Please check your domestic electri-
cal installation.
Replace the fuse.
Please turn the selector dial and
press the button 5 again.
If the laundry are to be washed
immediately, cancel the delay
start.
Deactivate the Child Lock function.
Wait for the electricity restore.
The appliance will start again from
the same interrupted washing
phase.
Redistribute the load manually or
load more laundry and select the
spin programme.
Reduce the detergent quantity or
use another one.
27