Renlig FWM7D5 Handbuch Seite 10

ENGLISH
Display
A
Delay Start button
The display shows the following information:
•
A
B
– Child safety lock.
•
B
– Duration of the selected programme.
– Selected drying time
– Delayed start.
– Alarm codes.
– Incorrect option selection.
– End of programme.
The programme can be delayed from 30 min - 60 min -
90 min, 2 hours and then by 1 hour up to a maximum of
20 hours by means of this button.
This device permits you to leave the appliance un-
attended during it's functioning.
After selecting a programme, the duration is dis-
played in hours and minutes (for example
The duration is calculated automatically on the ba-
sis of the maximum recommended load for each
type of fabric. After the programme has started,
the time remaining is updated every minute.
After selecting a drying programme the drying
time is shown in minutes or hours and minutes. Af-
ter the programme has started, the time remaining
is updated every minute.
The Selected delay set by pressing the relevant
button appears on the display for a few seconds,
then the duration of the selected programme is dis-
played again. The delay time value decreases by
one unit every hour and then, when 1 hour re-
mains, every minute.
In the event of operating problems, some alarm co-
des can be displayed, for example
paragraph «What to do if...»).
If an option which is not compatible with the set
wash programme is selected, the message Err is
displayed at the bottom of the display for a few
seconds and the integrated red indicator light of
button 5 start flashing.
When the programme has finished the flashing
zero ( ) is displayed, the indicator light 4 and the
indicator light of button 5 go out and the door can
be opened.
10
).
(see