Changing The Light Bulb - Electrolux EK107000 Bedienungsanleitung

refrigerator lamp starts to flash. Make
sure after closing that the doors are fully
sealed. The self-closing hinges assist this.
The cooling time for beverages and other
■
products can take up to 6 hours from
room temperature down to the refrigera-
tor temperature. The warmer they are
when put in, the longer this time will be.
Re-setting the temperature control has
■
no effect on the cooling rate, only on
the temperature reached.
Allow warm or really hot products cool
■
down outside the refrigerator.
Condensation can form on the glass
■
shelves if products are stored which emit
water vapour.
As the electronic control in the refrigera-
■
tor only defrosts about once per day, the
ice formation on the rear wall in the ref-
rigerator itself can be more marked than
is usual in previous refrigerators.
Be careful that products do not come
■
into contact with the rear wall of the ref-
rigerator so that they do not freeze to it
and that, during defrosting, water does
not get diverted into the refrigerator.
Take the temperature only in containers
■
with liquids; never measure the air tem-
perature.
When filling be careful that:
■
– Oil and fats do not come into contact
with the polymer parts and the door
seals.
– The coldest locations in the refrigera-
tor for any setting of the temperature
controller are at the back wall and
above the lowest shelf. Sensitive pro-
ducts should therefore be put on the
lowest shelf.
– To avoid possible warming of the pro-
ducts, keep them clear of the lamp.
this will also guarantee sufficient ven-
tilation for the lamp.
32
Example of how to use:
■
– Freeze and store foodstuffs and make
ice in the freezer compartment.
– On the shelves from top to bottom:
baked products, ready-made meals,
dairy products, meat and sausages.
– In the suspended trays from top to
bottom: butter and cheese, tubes,
small cans and eggs, large bottles.
– In the vegetable compartment:
vegetables, fruit and salad.

Changing the light bulb

A defective bulb must be replaced at once.
Switch off the power supply. Remove the
■
plug or trip the circuit breakers.
Pull off the lamp protection cover from
■
the side (fig. (). When fitting the new
light bulb, you will need to reassemble
the existing o-ring (fig. (a). Unscrew the
bulb and replace with a new item.
(
(
a