Start-Up And Operation - curaprox CHS 100 Handbuch

start-up and operation

imPortant
state of Charge
When the hydrosonic is just turned off or put on the charger the Leds indicate
the mode of application and the state of charge. the indication of the battery
charge is displayed as follows:
1-25% Charged 25-90% Charged
LoW battery Warning
CLeaning mode – When turned on
66
Charge the hydrosonic for
24 hours before first use.
a fully charged battery will
last for about 40 minutes.
90-100% Charged
the lowest Led will illuminate for about
one minute.
Power button: Press for a short moment
to turn on or off.
Press longer to change from intensive to soft
and to massage. the next time you turn the
device on, the cleaning mode you selected last
will be applied.
start-uP
1. Place the brush head on the handpiece with the bristles to the front of the
handpiece until it locks into place.
2. Plug your charger into an electrical outlet and place the handpiece on the
charger. the state of charge indicator displays the state of charge for one
minute and the hydrosonic is being charged.
3. Would you like to know the state of charge? simply take the hydrosonic
from the charger and the state of charge will be displayed for one minute.
it is also displayed after you turn the hydrosonic off.
4. Press briefly to turn on: the cleaning mode you selected last is applied.
after the first start, the hydrosonic will apply the soft mode. Press
longer to change the cleaning mode - from soft to intensive and to
massage.
display intensive: all three Leds are on.
display soft: the two upper Leds are on.
display massage: the uppermost Led is on.
intensive
32,000 sonic motions per minute for full
cleaning range. ideal for optimal removal of
biofilm bacteria.
soft
42,000 sonic motions per minute for a reduced
cleaning range. to clean sensitive teeth and
gums gently and safely.
massage
for a massage of your gums.
CLeaning mode
the hydrosonic offers three cleaning modes: intensive, soft and massage. the
cleaning mode is shown when the hydrosonic is turned on. you can change the
cleaning mode by pressing the power button for about two seconds. brief press-
ing turns the brush on or off.
67