Flash Triggering; Maintenance - Hensel Rc/Rf Bedienungsanleitung

HENSEL Studiotechnik Radio Flash Trigger and Power Control System RC/RF
7
8
9

Flash triggering

With correctly installed receiver and transmitter and proper
channel selection flashes can be released by pressing the
TEST button 3 or by releasing the camera shutter.
Additional features for flash units
with built-in receiver
The buttons 1a and 1b allow further options for HENSEL flash
units with a built-in receiver. A single click on the respective
button reduces and increases the flash power by 1/10 f-stop.
Pressing button 1a for longer than 3 seconds the modeling
light switches from FULL to OFF and PROP, respectively.
The Receiver is equipped with an interface socket 10 for
HENSEL power packs.

Maintenance

The HENSEL Remote Control System RC/RF
maintenance-free. Because of the low energy consumption of
the transmitter a battery
assumed depending on the degree of utilization.
The battery of the Radio Transmitter can be exchanged by
unscrewing screw 6 at the bottom of the unit. This provides
access to the electronics and the battery can be removed from
the clips and exchanged. Before reinstallation of the new
battery the polarity must be observed. The positive pole
should be pointed at that side of the unit where the Power
Down 1a button is located.
User Manual - Page 12 -
lifetime of 1 to 2 years can be
is almost