Hensel RC/RF Bedienungsanleitung Seite 12

HENSEL Studiotechnik Radio Flash Trigger and Power Control System RC/RF
Default
factory setting:
Channel 1
5 Start-up and channel selection – Receiver
For operation with flash units not equipped with a built-in
receiver the external receiver is to be attached to the
synchronization socket of the flash unit. After switching the unit
ON by using the main switch the green LED 8 of the receiver is
flashing. For channel selection the DIP switch of the receiver is
used. Combining both setting positions for the DIP switches four
different options are available. For channel setting, please refer
to the figure on page 1 of this manual.
The built-in receiver of the PLUS versions of the EXPERT
PRO / INTEGRA PRO series is switched on by pressing the RC
button. The channel can be selected by pressing the Flash
Control Switch once. By turning the knob channels from 1 to 4
can be selected as shown on the LED display above. After 3
seconds delay the channel is set and the display changes to the
flash power setting.
The built-in receiver of the PORTY Premium power pack will be
powered on together with the flash unit. The channel selection
can be performed by turning the knob lateral on the housing by
means of a screwdriver.
6 Start-up and channel selection - Transmitter
The Radio Transmitter has no built-in main switch for
switching the unit ON. The transmitter is to be connected to
the camera either by attaching it to the Hot Shoe of the
camera or by connecting the camera to the synchronization
socket 4 using the provided synchronization cable.
transmitter is connected to the Hot Shoe the unit must be
carefully tightened using the locking screw 5. Using the DIP
switch 6 at the bottom side of the unit the working channel can
be set. Combining both setting positions for the DIP switches
four different options are available. The same channel must be
set at the corresponding receiver. For channel setting, please
refer to the figure on page 1 of this manual.
User Manual - Page 11 -
If the