Safety Instructions; Overview Of Controls - Hensel Rc/Rf Bedienungsanleitung

HENSEL Studiotechnik Radio Flash Trigger and Power Control System RC/RF
For all other flash units not fitted with a built-in Receiver
HENSEL Studiotechnik offers the usage of an external
receiver as accessory.
Transmitter flashes can be triggered, but additional features
like flash power adjustment and changing modeling light
options (FULL/OFF/PROP) are not available.
Every use of the equipment that differs from its prescribed use
is prohibited. In particular, controlling of electronical items or
machines other than described above is prohibited.
3
Changing this unit is strictly prohibited. The housing is splash-
proof but not watertight. Therefore protect the equipment from
humidity. The operation during rain is not recommended
because over the years moisture might ingress into the
housing causing damage to the electronics.
4

Safety instructions

Overview of Controls

Radio Transmitter – Controls -
1a Flash Power Down and Modeling light options*
1b Flash Power Up button*
2 Channel selector for 4 channels (DIP switch)
3 Test button for flash triggering
Socket for Sync Cable, ∅ 2.5 mm
4
5 Locking Screw for mounting to the Hot Shoe of the camera
6 Gap for opening the battery compartment
Radio Receiver – Controls -
7 Channel selector for 4 channels (DIP switch)
8 LED green (sync voltage applied)
9 LED red (low battery)
10 Interface socket
11 Gap for opening the battery compartment
* Additional features only available in flash units with
built-in receiver.
User Manual - Page 10 -
In connection with the Radio