Setting Up Internet Control; Restoring The Factory Settings; Led Flashing Sequences And Transmission Behaviour - eQ-3 MAX! Cube Bedienungsanleitung

6.4 Setting up Internet control

If you want to be able to control your system using the In-
ternet control feature or via a smartphone, then Internet
access must also be enabled and Internet control must
be set up.
Please note that the MAX! Cube can only be ac-
cessed with the MAX! Internet control feature if the
local MAX! software is inactive.
• Set up your user account for portal operation using the
local MAX! software.
• Therefore, click „Settings" and „Internet control". Ple-
ase enter a username and a password. Both may only
contain letters and numbers.
• Log out to deactivate the local MAX! software.
• After a brief delay, the Internet LED lights up continuous-
ly. The connection to the MAX! Portal is active and the
MAX! Cube is now ready for operation.
You now have a flexible means of controlling and configu-
ring your MAX! system and can access it from home as
well as via the Internet.

7. Restoring the factory settings

The MAX! Cube can be reset to the initial state manually.
When the factory settings are restored, all informa-
tion about taught-in devices and all settings made
are lost and cannot be retrieved.
• Disconnect the MAX! Cube from the power supply and
wait for 1 minute.
26
• Press and hold down the reset button and at the same
time reconnect the power supply.
• The Power LED lights up and then starts to flash.
• The Power LED then lights up permanently again. The
factory settings are restored.
8. LED flashing sequences and
transmission behaviour
LED State
Power LED off
LED
LED flashing
LED
permanently lit
Internet LED off
LED
LED flashing
LED
permanently lit
Battery LED off
LED
LED flashing
Meaning
Power supply interrupted
MAX! Cube starting up and
performing self-test
Self-test completed successfully
and power supply present
No network connection (check
cabling)
Network connection to router
established, no connection to
MAX! portal
Connection to MAX! portal is
active
All MAX! components have
sufficient battery voltage
Batteries of a MAX! component
need to be replaced (see MAX!
software)
27