Installing The Max! Software; System Compatibility; Installing The Devices - eQ-3 MAX! Cube Bedienungsanleitung

6.2 Installing the MAX! software/

system requirements
You need the MAX! software to teach in MAX! components
via the MAX! Cube, for configuration purposes and to call
up device status messages.
The MAX! Cube must be supplied with power and
connected to router for the installation of the MAX!
software.
When the MAX! Cube is being set up, DHCP must
be activated on the router. Alternatively, the following
address can be manually assigned to the MAX! Cube
via the MAX! software: 192.168.0.222.
• First download the software for your MAX! House So-
lution. You will find the download link for your installtion
file on the top of the MAX! Cube package.
• Install the software on your PC. The software launches
automatically and the software interface is displayed in
your browser.

System compatibility:

Operating system:
Windows XP / Windows Vista / Windows 7 / Windows 8*,
®
Mac OS X 10.6-10.9*
Browser:
Internet Explorer® Version 11*,
Mozilla Firefox® Version 26*,
Safari Version 6 or 5.1.9 (Mac)*,
Google Chrome Version 31* and other Browsers
24
*Previous and later versions may also be applied.

6.3 Installing the devices

In order to enable communication between MAX! com-
ponents, the devices have to be taught in to one another.
The devices should be installed room by room and, within
rooms, one device at a time. To do this, proceed as follows:
If you have already used a MAX! Room Solution or
a MAX! Radiator Solution, please restore the factory
settings of all devices before teaching in to the MAX!
C u b e. Fo r f u r t h e r d et a i l s , p l e a s e s e e t h e
corresponding operating manual.
• Install the device that you want to teach in on the MAX!
system (e.g. MAX! Radiator Thermostat) by following the
instructions in the relevant operating manual.
• Select „New device" in the software to switch the MAX!
Cube to teach-in mode.
• Set the device that you want to teach in on the MAX! sys-
tem (e.g. MAX! Radiator Thermostat) to teach-in mode by
following the instructions in the relevant operating manual.
• The device appears in the software.
• In the software, click „Next".
• Assign a name for the device. Allocate the device to
a room.
• Follow the same procedure for all the other devices that
you want to teach in on the MAX! system.
25