Santec VTC-8320WDP Bedienungsanleitung Seite 55

Bedienungsanleitung / User manual
VTC-8120WDP / VTC-8122WDP / VTC-8320WDP / VTC-8322WDP
L/L Sync (LineLock Synchronsation):
INT: internal synchronisation
LL: LineLock synchronisation
Note: If you use 12 V DC, synchronisation iss et to „internal".
If you use 24 V AC, you can also use LineLock synchronsation.
Monitor type:
Change the settings according to your monitor. LCD/CRT monitors can be
used.
Factory Reset:
Return to factory settings.
Communication:
Protocols: Pelco-D is supported by default.
Camera ID: Camera ID can be set to 0-255.
Baud rate:
Save/reboot: Save the set values and reboot the camera.
Previous:
Exit:
Save the current settings and return to main menu.
Note: RS-485
The camera can also be parameterised remotely by using a RS-485 connection. The
communication is done via the Pelco D protocol. The command to open/close and to
confirm the camera OSD is "PRESET 95". Using the up/down/left/right commands of
the keyboard joystick, you can navigate through the OSD menu (not applicable for G-
sensor OSD and light OSD).
_________________________________________________________________________________

Baud rate can be set to 4800-57600.
Return to main menu.
- 55 -