Using The Remote Controller (Rm-Rk50) - JVC KD-R901 Bedienungsanleitung

q
• Return to the previous menu.
• iPod FRONT/iPod REAR: Switch the
setting between <Headunit Mode> and
<iPod Mode> * 6
[Hold].
• BT FRONT/BT REAR (Audio): Pause
playback.
w
• Enter "Call Menu" screen.
• Enter <Quick Call> preset method [Hold]. (See
page 33.)
• BT FRONT/BT REAR (Phone):
– Answer incoming call.
– End a call [Hold].
e
• Turn on the power.
• Attenuate the sound (if the power is on).
• Turn off the power [Hold].
• BT FRONT/BT REAR (Phone): Switch
the conversation media during a phone call
conversation.
r
Remote sensor
t
AUX (auxiliary) input jack

Using the remote controller (RM-RK50)

Installing the lithium coin battery (CR2025)
Caution:
• Danger of explosion if battery is incorrectly replaced.
Replace only with the same or equivalent type.
• Battery shall not be exposed to excessive heat such as
sunshine, fire, or the like.
If the effectiveness of the remote controller
decreases, replace the battery.
* 1
Also known as "Control dial" in this manual.
* 2
You can still adjust the volume during pause when
the selected source is CD/USB FRONT/USB
REAR/iPod FRONT/iPod REAR/BT FRONT/
BT REAR/iPod.
Before resume playback, check to be sure that you
have not raise the volume level too much.
* 3
For Bluetooth devices that support AVRCP 1.3.
* 4
You cannot select these sources if they are not ready
or not connected.
* 5
You cannot select these sources if they were disabled
in the <SET UP> menu (see <Source Select> in
"Menu operations" on page 31).
* 6
You can use this function only when <iPod Mode>
is available for the connected iPod (see pages 21
and 38).
Before using the remote controller:
• Aim the remote controller directly at the remote
sensor on the unit.
• DO NOT expose the remote sensor to bright light
(direct sunlight or artificial lighting).
Remote sensor
OPERATIONS
Continued on the next page
7