Sharp AR-FR22 U Bedienungsanleitung Seite 11

SETTING FOR PRINT-HOLD DISABLING
This program can be used to prohibit the storage of print jobs that are not protected by a
pass code when the print hold job function of print mode is used. The program can also be
used to prohibit the printing of print jobs that do not use the print hold job function.
• [FILES WITHOUT PASS CODE ARE NOT ALLOWED FOR STORE JOBS]
To prohibit the storage of print jobs that are not protected by a pass code, touch the
[FILES WITHOUT PASS CODE ARE NOT ALLOWED FOR STORE JOBS] checkbox
so that a checkmark appears.
When this function is enabled, print hold jobs that do not have a pass code will not be
stored in the machine. To use the print hold job function, configure the [Pass Code]
setting in the [Retention Settings] of the printer driver (page 2-12 of the OPERATION
MANUAL (for printer)).
The factory default setting is enabled (a checkmark appears).
• [DISABLING OF PRINT JOBS OTHER THAN PRINT-HOLD JOB]
If a printed document is left on an output tray after being printed in printer mode, it is
possible that another person might take the document and leak sensitive information.
This program is used to disable all print jobs other than print jobs that require printing to
be initiated from the operation panel of the machine. To prohibit jobs that are not print
hold jobs, touch the [DISABLING OF PRINT JOBS OTHER THAN PRINT-HOLD JOB]
checkbox so that a checkmark appears. To print a job when this program is enabled,
select "Hold Only" in the "Retention" field of the printer driver and then execute the print
command. To print a print job that is held using this setting, call up the stored job from
the operation panel of the machine and perform the "HOLD JOB LIST" procedure of the
print hold job function (page 5-2 of the OPERATION MANUAL (for printer)). When
printing is performed using the "Hold After Print" or "Sample Print" setting, the job will
not be printed. Instead it will be held and can be printed using the same method as
when "Hold Only" is selected.
The factory default setting is disabled (a checkmark does not appear).
DISABLING OF LIST PRINT
This program is used to disable printing of any of the following lists that are printed using
"LIST PRINT" in the custom settings (page 2-14 of "OPERATION MANUAL (for general
information and copier operation)").
"ALL CUSTOM SETTING LIST", "SENDING ADDRESS LIST"*
2
LIST"* ,
*1. Can only be selected when the fax or network scanner function is enabled.
*2. Can only be selected when the network scanner function is enabled.
Select the checkboxes of the lists for which you wish to disable printing and then touch the
[OK] key.
1
9
ENGLISH
, "SENDER CONTROL