Sharp QT-CD180H Bedienungsanleitung Seite 26

Recording to a Cassette Tape
Before recording:
When recording important selections, make a preliminary test to en-
sure that the desired material is properly recorded.
SHARP is not liable for damage or loss of your recording arising from
malfunction of this unit.
The ALC (Automatic Record Level Control) circuit automatically con-
trols the level of the input signal used for recording.
The VOLUME and X-BASS controls may be adjusted with no effect
on the recorded signal. (Variable Sound Monitor)
Metal and CrO tapes cannot be used for recording.
2
E-6
Recording from a CD
1
Set the FUNCTION switch to CD.
2
Load the disc to be recorded.
3
Load a blank cassette into the cassette compartment with the
side to be recorded on facing toward you.
4
Press the RECORD button.
5
Press the PLAY/PAUSE 0 6 0 6 button on the CD.
0 6 0 6 0 6
To stop recording:
Press the STOP/EJECT 7 button.
If the STOP or PLAY/PAUSE 0 6 button is pressed whilst recording,
or if the CD comes to its end, the tape deck will not stop.
To record a specific track:
Press the REVIEW/DOWN 5 or CUE/UP 4 button until the desired
track number is displayed, then start recording.
Recording from the radio
1
Set the FUNCTION switch to FM or AM.
2
Tune in to the station to be recorded.
3
Load a blank cassette into the cassette compartment with the
side to be recorded on facing toward you.
4
Press the PAUSE 6 6 6 6 6 button.
5
Press the RECORD button.
6
Press the PAUSE 6 6 6 6 6 button again.
To stop recording:
Press the STOP/EJECT 7 button.
Erasing a recorded tape
1
Set the FUNCTION switch to TAPE.
2
Load a tape into the cassette compartment with the side to be
erased facing toward you.
3
Press the RECORD button.