Sharp QT-CD180H Bedienungsanleitung Seite 25

Listening to a Cassette Tape
1
Set the FUNCTION switch to TAPE.
2
Open the cassette door by pushing the STOP/EJECT
3
Load a cassette into the cassette compartment with the side to
be played facing toward you.
4
Press the PLAY 1 1 1 1 1 button.
5
To advance the tape, press the STOP/EJECT
press the F FWD 3 3 button. To rewind, press the STOP/EJECT
3 3 3
7 7 7 7 7 button, then press the REWIND 2 button.
To interrupt playback:
Press the PAUSE 6 6 6 6 6 button during playback.
Press the PAUSE 6 6 6 6 6 button again to resume playback.
To stop playback:
Press the STOP/EJECT 7 button.
Precautions:
Be sure not to press the PLAY 1 1 1 1 1 and REWIND 2 buttons simultaneously, or
the tape will become damaged.
Before changing from one tape operation to another, press the STOP/EJECT
7 7 7 7 7 button.
Do not press the PAUSE 6 button whilst the fast forward or rewind operations are
in progress. The F FWD 3 or REWIND 2 button will not be released when the
tape end is reached. Once this occurs, press the STOP/EJECT
Cassette tape
For playback, use normal or low-noise tape for the best sound. (Metal or
CrO tape is not recommended.) For recording, use only normal tape.
2
Do not use C-120 tapes, or poor-quality tapes, as they may cause mal-
functions.
Before loading a tape into the cassette compartment, tighten the slack
with a pen or pencil.
Cassettes have removable tabs which prevent accidental recording or
erasing from taking place. Removing the tab will protect the correspond-
ing side from being erased. Cover the tab holes with adhesive tape to
erase or record again.
Tab for side B (2) Tab for side A (1)
Headphones
7 7 7 7 7 button.
7 7 7 7 7 button, then
Before plugging in or unplugging the headphones, make sure the volume
level is reduced.
Be sure your headphones have a 3.5 mm (1/8") diameter plug and are
between 16 ohms and 50 ohms impedance. The recommended imped-
ance is 32 ohms.
When headphones are connected, the speakers are disconnected auto-
7 7 7 7 7 button.
matically. Adjust the VOLUME control for desired volume.
Side A (1)
To the PHONES socket
E-5