Sharp QT-CD180H Bedienungsanleitung Seite 23

Listening to a CD
MIN MAX
Precautions:
When "Cd" or track number is displayed, the power is connected.
If you will not be using the CD player, set the FUNCTION switch to STAND-BY.
Do not open the CD compartment whilst the disc is rotating.
If the disc is damaged, dirty, or loaded upside down, the total number of
tracks will not appear.
Clean, replace, or reload the disc properly.
Keep foreign objects out of the CD compartment.
Subjecting the unit to shock or vibration may cause mistracking.
Keep the CD compartment closed except when loading discs.
Playing certain compact discs at a high volume may cause mistracking.
In this case, listen at a lower volume.
If TV or radio interference occurs during CD operation, move the unit
away from the TV or radio.
1
Set the FUNCTION switch to CD.
2
Open the CD compartment.
3
Place a compact disc on the spindle, label side up.
8 cm (3") discs may be played without an adaptor.
4
Close the CD compartment.
5
Press the PLAY/PAUSE 0 6 0 6 button to start playback from track 1.
0 6 0 6
0 6
6
Turn the VOLUME control to increase or decrease the volume.
7
Press the X-BASS button to emphasise the bass sound.
To interrupt playback:
Press the PLAY/PAUSE 0 6 button during playback.
Press the PLAY/PAUSE 0 6 button again to resume playback.
To stop playback:
Press the STOP button.
To listen to the track being played again:
During playback, press the REVIEW/DOWN 5 button.
To move to the beginning of the next track:
During playback, press the CUE/UP 4 button.
Notes:
To skip a number of tracks at one time, press the REVIEW/DOWN
5 or CUE/UP 4 button repeatedly until the desired track number
is shown.
To start playing a desired track, press the REVIEW/DOWN 5 or
CUE/UP 4 button whilst in the stop mode to select the track num-
ber, and then press the PLAY/PAUSE 06 button.
E-3