Connection - JVC SX-WD5 Bedienungsanleitung

Connection

7
Precautions
Before connecting:
• Make sure to match the polarity (ª and ·) when connecting the speaker cords.
• Turn off the power to the amplifier before connecting the speaker system; otherwise,
the speakers may be damaged.
• The impedance of the speaker is 6 Ω.
If this does not match with the speaker impedance range indicated on the amplifier,
you cannot connect this system to the amplifier.
• The maximum power handling capacity of the SX-WD5 is 100 W. Excessive input will
result in abnormal noise and possible damage.
Daily operations and maintenance:
• Be sure to turn down the volume level on the amplifier to prevent unwanted noise
before performing following operations:
– Turning on or off other components
– Operating the amplifier
– Tuning FM stations
– Fast-forwarding a tape
– Continuously reproducing high frequency oscillation or high pitch electronic sounds
– Connecting or disconnecting a microphone
• When using a microphone, do not aim it at the speakers or use it near the speakers;
otherwise, the howling which occurs may damage the speakers.
• Before replacing the cartridge, always turn off the power both to the amplifier and to
the turntable; otherwise, the clicking noise may damage the speakers.
7
Connecting the speaker system to the amplifier
• Twist and remove the insulation at the end of each speaker cord before
connecting.
· terminal ª terminal
(Black hoop) (Red hoop)
Silver
Copper
1 2
To the speaker ª
terminal of amplifier
To the speaker ·
terminal of amplifier
3
5