Status Signals - Otto Bock C-Brace Gebrauchsanweisung

LED on LED on bat­
power tery charger
supply
Error after disconnecting the battery charger (error on self-test)
Beep Error
signal
5 x long Self-test error

12.2.3 Status signals

Battery charger is connected
LED on LED on bat­
power tery charger
supply
Battery charger disconnected
Beep Event
signal
1 x short Self-test completed successfully.
Battery charge level
The current battery charge level can only be displayed by connecting the battery charger and
power supply to the product.
Battery char­
ger
Battery charge level less than 50%
Battery charge level over 50%
Battery is fully charged
Battery charger connected/disconnected
Beep signal
1x short, pause, 2x
short
1x short, 2x long
1 x short
Error
Event
Power supply and battery charger operational
Event
Battery charger connected
Charging mode started (3 sec. after connection of battery charger)
Battery charger disconnected after charging mode, self-test OK.
Resolution
inspect the product, battery char­
ger and power supply.
Resolution
• Restart the product by connecting
and disconnecting the battery char­
ger (up to three times)
• If the error persists, the product must
be inspected by
Ottobock Service Centre
an authorised
Ottobock | 67