Activating The Additional Mode (2Nd Mode); Activating Lom; Switching From An Additional Mode Back To Basic Mode - Otto Bock C-Brace Gebrauchsanweisung

from to Press top but­
ton ( )
LOM 1st 1 x long
LOM 2nd
INFORMATION
If 4 short beep signals are emitted, this means switching could not be completed. The most fre­
quent cause of this is that the weight was not taken off the leg after the first beep signal.

7.4.2 Activating the additional mode (2nd mode)

INFORMATION
Before the first step, always check whether the selected mode corresponds to the desired
motion type.
1) Press and hold the lower button ( ).
→ A long beep signal is emitted.
2) Take weight off the leg
→ Two short beep signals sound to indicate successful switching to the additional mode
(2nd mode).
INFORMATION: If four beep signals sound, the weight was not taken off the leg
correctly or for long enough. Repeat the process to correctly switch to the desired
mode.

7.4.3 Activating LOM

From basic mode (1st mode) to LOM:
► Briefly press the lower button ( ) twice.
→ Three short beep signals are emitted.
→ The product has successfully switched to LOM.
From additional mode (2nd mode) to LOM:
1) Briefly press the lower button ( ) twice.
→ A long beep signal is emitted.
2) Take weight off the leg .
→ Three short beep signals are emitted.
→ The product has successfully switched to LOM.
INFORMATION
LOM is automatically deactivated by switching to basic mode (1st mode) or the additional mode
(2nd mode).

7.4.4 Switching from an additional mode back to basic mode

1) Press and hold the upper button ( ).
→ A long beep signal is emitted.
2) Take weight off the leg
60 | Ottobock
Press bottom Beep sig­
button ( )
1 x long
and keep it still for approx. 1 second.
and keep it still for approx. 1 second.
Additional
nal action
1 x long Relieve load on
leg
1 x long Relieve load on
leg
Beep sig­
nal
1 x short
2 x short