Warnings/Error Signals - Otto Bock C-Brace Gebrauchsanweisung

Beep signal
1x long
2x short
3x short
3x short
4x short

12.2.2 Warnings/error signals

Error during use
Beep signal
3 x long
5 x long
10x long, then switch­
ing to empty battery
mode
Beep signal
1 x short at intervals
of approx. 1 second
Ongoing short beep
signal
4 x short then pause,
duration 30 seconds
1 x short, interval
5 seconds, duration
10 minutes
Additional action performed
Button 1 or 2 was pressed long
or
Button 2 was pressed 2x short
Take weight off leg
Take weight off leg
Button 2 was pressed 2x short
Take weight off leg
Event
Battery charge level under 10 %
Battery charge level under 5 %
Battery charge level approx. 1 %
Event
Overheated hydraulic unit
Error of moderate severity:
e.g. a sensor is not operational
Switch to safety mode
Walking possible with restrictions
Loss of spring contact/loss of
sensor screw contact
Active safety mode
Walking possible with restrictions
Event
When the beep signal sounds,
weight must be taken off the leg to
switch to the corresponding mode.
Switching to the additional mode
(2nd mode) performed successfully
Switching to LOM performed suc­
cessfully
Switching to LOM performed suc­
cessfully
No switching performed
Check the following points:
• Was weight put on the leg with
the product or was there move­
ment in the knee joint?
• Is the spring element in the foot
region bent and
defective?
• Was calibration performed?
Required action
Reduce activity
Attempt to reset this error by con­
necting the battery charger. If this
error persists, the product must be
inspected by an authorised
Ottobock Service Centre.
Restore contact with the spring or
sensor screw. By pressing the top
button on the joint unit (5 seconds),
check the sensor contact.
If this error persists, the product
must be inspected by an author­
ised Ottobock Service Centre.
The product must be inspected by
an authorised Ottobock Service
Centre
Ottobock | 65
therefore