Shark Powerdetect UV Reveal RV3000XEEU Serie Bedienungsanleitung Seite 12

BASE MAINTENANCE
CAUTION: Before performing any maintenance, unplug the base from the socket.
MAINTAINING THE BASE WATER TANKS
CLEAN WATER TANK
1. Clean the base clean water tank before every refill,
or once every 30 days.
2. Wash the clean water tank with warm water and
soap. Rinse thoroughly.
3. Add room-temperature water up to the fill line
and no more than 355mL of Shark Multi-Surface
Cleaner to the fill line.
NOTE: ONLY use the provided Shark-branded floor cleaner.
DO NOT reinstall any water tanks filled with warm water. Always use room-temperature water in the tanks.
DO NOT move the base while the water tank is full.
CLEANING THE BASE RAMP
s h a r kc l e a n . e u
GREYWATER TANK
1. The greywater tank collects and stores dirty water
after every pad wash.
2. This tank should be emptied and cleaned every
30 days, or as needed.
3. To empty the tank into a toilet. open the lid and
pour out the dirty water.
4. Add a small amount of soap to the tank and rinse
it thoroughly in the sink with warm water.
5. Allow the tank to air-dry for at least 48 hours
before reinstalling.
Clean the base ramp every three months or as needed.
1. Carefully lift the ramp up and away from the base.
2 Use a damp cloth to wipe down the ramp.
3. To reinstall, lift the ramp slightly above the base,
align, and press down until the ramp clicks into place.
BASE MAINTENANCE
CAUTION: Before performing any maintenance, unplug the base from the socket.
CLEANING THE BASE-TO-ROBOT CONNECTIONS
Water Outlets
1. Locate the charging contacts, water outlets, and
debris intake.
2. With a dry cloth, gently dust off both charging
contacts on the base. Remove any dust or debris
from the debris intake
STARTING A BASE SELF-CLEAN CYCLE
Run a base self-cleaning cycle every 6 months or as needed.
DO NOT put anything other than 5% white vinegar and water into the water tank when performing a self-clean cycle.
DO NOT use 5% white vinegar unless performing a self-clean cycle.
Charging Contacts
Water Outlets
Debris Intake
3. Use a dry cloth to wipe the water outlet nozzles on
the base to remove any stuck-on debris or other
blockages.
1. Send the robot on mopping mission and allow it to
run for at least 5 minutes.
2. While the robot is mopping, empty the clean
water and greywater tanks. Fill the clean water
tank up to the YELLOW fill line with a 1:1 mixture
of water and white vinegar.
3. Reinsert both tanks into the base.
4. After 5 minutes of mopping, tap
to initiate docking.
5. Allow the robot to complete a mop pad wash
cycle on the base.
6. Once the wash cycle is complete, empty the
contents of both base water tanks into the sink.
7. Remove the robot from the base and power it
off by holding the Power/Dock
seconds. Remove the water tank and empty it in
the sink.
8. Reinstall the water tank on the robot and slide the
robot onto the base with the Shark logo facing
upside down to power it on.
on the robot
button for 3
s h a r kc l e a n . e u