Operation - Hilti TE 300-AVR Bedienungsanleitung

Rated current input
Weight in accordance with EPTA procedure 01/2003
Single impact energy in accordance with EPTA procedure
05/2009
4.2 Noise information and vibration values determined in accordance with EN 60745
The sound pressure and vibration values given in these instructions have been measured in accordance
with a standardized test and may be used to compare one electric tool with another. They may be used
for a preliminary assessment of exposure. The data given represents the main applications of the electric
tool. However, if the electric tool is used for different applications, with different accessory tools, or is poorly
maintained, the data may vary. This may significantly increase exposure over the total working period. An
accurate estimation of exposure should also take into account the times when the tool is switched off, or
when it is running but not actually being used for a job. This may significantly reduce exposure over the
total working period. Identify additional safety measures to protect the operator from the effects of noise
and/or vibration, for example: maintenance of the electric tool and the accessories, keeping the hands warm,
organization of work patterns.
Noise emission values determined in accordance with EN 60745-2-6
Measured sound power level (L
Uncertainty for the sound power level (K
Sound pressure level (L
Uncertainty for the sound pressure level (K
Total vibration (vector sum of three directions), measured in accordance with EN 60745-2-6
Chiseling (a )
h, Cheq
Uncertainty (K)

5 Operation

Fitting / removing the accessory tool
WARNING
Risk of injury! The accessory tool gets hot during use and may also have sharp edges.
▶ Wear protective gloves when changing the tool.
Note
Check the accessory tool for damage or uneven wear each time before use and replace it
if necessary.
Note
Use only the recommended grease supplied by Hilti. Use of unsuitable grease may cause
damage to the product.
Removing / fitting the chuck
Positioning the chisel
Note
The chisel can be adjusted to 12 different positions (in 30° increments). This ensures that
flat chisels and shaped chisels can always be set to the optimum working position.
Locking the chisel
Chiseling
14
230 V
)
WA
)
WA
)
pA
)
pA
TE 300­AVR
4.5 A
3.8 kg
3.3 J
102 dB(A)
3 dB(A)
91 dB(A)
3 dB(A)
13.5 m/s²
1.5 m/s²
2
3
4
5