Adjusting The Parquet/Carpet Brush - Grundig VCC 7670 A Handbuch

OPERATION
Attaching/removing the hose
1
T o attach the hose
in the direction of arrow until it is aligned with
the housing.
The tabs on the hose cap
■
correctly.
2
T o remove the hose
hose cap and pull it.
G
Attaching/removing the
telescopic tube
1 A ttach the telescopic tube
2
P ull the telescopic tube
to remove it.
3
Y ou can extend or shorten the telescopic tube
by sliding the telescopic tube adjustment
N
latch back and forth.
18 ENGLISH
______________________________________
push the hose cap
R
must be seated
G
, press on the tabs on the
R
to the handle
N
from the handle
N
Attaching/removing the
parquet/carpet brush
G
1
A ttach the telescopic tube
carpet brush
2
P ull the telescopic tube
carpet brush
Adjusting the parquet/carpet
brush
Perform the following actions on the adjustment
latch located on the parquet/carpet brush
Use "
■
parquet.
Use "
■
.
P
Operation
1 P lug in the appliance after pulling the power
plug located at the back of the appliance.
Caution
Stop pulling the appliance cable when it comes
7
to the yellow mark located on it. After the yel-
low mark the red mark comes. Do not pull any
P
more after reaching the red mark.
2
P ress the on/off button
appliance.
to the parquet/
N
.
I
from the parquet/
N
to remove it.
I
" position for hard floors and
" position for rugs and carpets.
to switch on your
A
;
I