Standard Accessories; Specifications; Maintenance And Inspection - Hitachi Koki C 7UR Bedienungsanleitung

English
SYMBOLS
WARNING
The following show symbols used for the machine.
Be sure that you understand their meaning before
use.
C7UR : Circular Saw
To reduce the risk of injury, user must read
instruction manual.
Always wear eye protection.
Always wear hearing protection.
Only for EU countries
Do not dispose of electric tools together with
household waste material!
In observance of European Directive 2002/96/
EC on waste electrical and electronic equipment
and its implementation in accordance with
national law, electric tools that have reached
the end of their life must be collected separately
and returned to an environmentally compatible
recycling facility.
V
Rated voltage
Cutting depth
P
Power Input
n
No-Load speed
0
Weight (without cord)
kg
Switching ON
Switching OFF
Disconnect mains plug from electrical outlet
Blower
Prohibited action
Class II tool

STANDARD ACCESSORIES

In addition to the main unit (1 unit), the package
contains the accessories listed in the below.
○ Saw Blade (Dia. 185 mm) (mounted on tool) ................1
○ Hex. Bar wrench (mounted on tool)...............................1
○ Guide ............................................................................1
○ Wing-bolt ......................................................................1
○ Lock Spring ...................................................................1
○ Lever (short type) ..........................................................1
○ Dust collector ................................................................1
Standard accessories are subject to change without notice.
APPLICATIONS
Cutting various types of wood.

SPECIFICATIONS

The specifi cations of this machine are listed in the Table on
page 74.
NOTE
Due to HITACHI's continuing program of research and
development, the specifi cations herein are subject to
change without prior notice.
MOUNTING AND OPERATION
Action
Adjusting the cutting depth
Adjusting the angle of inclination
(0o – 45o)
Adjusting the angle of inclination
(45o – 55o)
Regulating the guide
Cutting line
Using the cord holder
Mounting the dust collector set
Switch operation
*1
Dismounting the saw blade
Cutting (Do not use the tool with
only the blower function.)
Mounting the Saw Blade
Adjusting the base and saw blade
to maintain perpendicularity
Selecting accessories
*1 Before beginning work, check to ensure that operating
the switch correctly turns the tool ON and OFF.
While the tool is plugged in to the receptacle, ensure that
the sawblade stops when the switch is turned OFF.

MAINTENANCE AND INSPECTION

1. Inspecting the saw blade
Since use of as dull saw blade will degrade effi ciency
and cause possible motor malfunction, sharpen or
replace the saw blade as soon as abrasion is noted.
2. Inspecting the mounting screws
Regularly inspect all mounting screws and ensure that
they are properly tightened. Should any of the screws be
loose, retighten them immediately. Failure to do so could
result in serious hazard.
3. Inspecting the carbon brushes (Fig. 15)
The motor employs carbon brushes which are consumable
parts. Since an excessively worn carbon brush can result
in motor trouble, replace the carbon brushes with new
ones having the same carbon brush No. ⓐ shown in the
fi gure when it becomes worn to or near the "wear limit" ⓑ.
In addition, always keep carbon brushes clean and ensue
that they slide freely within the brush holders.
10
Figure Page
2
3
2
4
2
5
3
6
3
7
3
8
3
9
3
10
4
11
4
12
5
13
5
14
75
―