Operation - Laserworld RTI NEO SIX RGB 2 Bedienungsanleitung

Manual: RTI NEO SIX RGB 2

8. Operation

1. Power
Make sure that your device is provided with the correct voltage. Wrong voltage could lead
to irreparable damages. Please find the correct voltage data in the synoptical table at the
end of this manual as well as at the rear side of the device. It must be ensured that the
device is not directed to people or inflammable objects during installation.
Connect the power cable to ‚Power in' at the device and then to the mains.
2. DMX in / DMX out
The device can be controlled via DMX. There are a ‚DMX in' (DMX input) and a ‚DMX out'
(DMX through) interface on the rear side of the device. Connect ‚DMX in' via a DMX cable
to a DMX controller. ‚DMX out' is intended to Daisy Chain the control signal to the ‚DMX
in' interface of a further RTI NEO device. The LED shows if there is any signal present. It
does not flash if there is a corrupt signal coming in.
The device offers 60 channels, starting from the selected start address. Each universe can
control a maximum of 8 devices and each of the 6 outputs can be controlled individually.
Each output of the device uses 10 channels as shown here:
Channel
1 Red
2 Green
3 Blue
4 Pan Coarse
5 Pan Fine
6 Tilt Coarse
7 Tilt Fine
8 Off / Dot / Gobo 0
page 8 / 30
Value Effect
0 - 255 Red: 0 - 100%
0 - 255 Green: 0 - 100%
0 - 255 Blue: 0 - 100 %
0 - 255 Pan MSB
0 - 255 Pan LSB
0 - 255 Tilt MSB
0 - 255 Tilt LSB
Blackout
1 - 10 Dot
11 - 20 Rectangle
21 - 30 Triangle
31 - 40 Line horizontal
41 - 50 Line vertical
51 - 60 2 dots horizontal
61 - 70 2 dots vertical
71 - 80 3 dots horizontal
81 - 90 3 dots vertical
91 - 100 Circle
101 - 110 4 quarter circle
111 - 120 Test picture
121 - 130 Rectangle with grating
Comment
Safety channel