T+A Elektroakustik DAC 8 DSD Betriebsanleitung Seite 54

Loudspeaker
and signal
cables
Changing the
batteries


Care of the
unit
Storing the
unit
54
Loudspeaker cables and signal cables (inter-connects) have a
significant influence on the overall reproduction quality of your sound
system, and their importance should not be under-estimated. For this
reason  recommends the use of high-quality cables and
connectors.
Our accessory range includes a series of excellent cables and
connectors whose properties are carefully matched to our speakers
and electronic units, and which harmonise outstandingly well with
them.
For difficult and cramped situations the  range also includes
special-length cables and special-purpose connectors (e. g. right-
angled versions) which can be used to solve almost any problem
concerning connections and system location.
The FM8 is fitted with an internal rechargeable battery (Li-Ion battery),
which cannot be removed or replaced by the user. If you eventually
notice that the battery only retains a little of its original capacity, and
the period you can use the FM8 is greatly reduced, then it is time to
contact your  dealer and ask him to fit a replacement battery.
Caution!
If the battery is replaced improperly, there is danger of explosion.
Always replace batteries by batteries of the same or an equivalent
type.
Batteries shout not be exposed to excessive heat like sunshine, fire or
the like.
Disposing of exhausted batteries:
Exhausted batteries must never be thrown into the household waste!
They should be returned to the battery vendor (specialist dealer) or
your local toxic waste collection point, so that they can be recycled or
disposed in a proper way. Most local authorities provide collection
centres for such waste, and some provide pick-up vehicles for old
batteries.
Always disconnect the unit from the mains supply before cleaning it.
The surfaces of the case should be wiped clean with a soft, dry cloth
only.
Never use solvent-based or abrasive cleaners!
Before switching the unit on again, check that there are no short-
circuits at the connections, and that all cables are plugged in correctly.
If the device has to be stored, place it in its original packaging and
store it in a dry, frost-free location. Storage temperature range 0...40
°C