T+A Elektroakustik DAC 8 DSD Betriebsanleitung Seite 40

Display elements / Remote control receiver
Remote
control
receiver
Display
40

Note regarding the use of headphones:
Continuous listening to programme material at very high
volume using headphones or earphones can result in
permanent loss of hearing. You can avoid subsequent health
problems by avoiding continuous listening at high volume
through headphones or earphones.
(behind the Perspex screen)

When using the remote control system please point the FM8
handset in the direction of the receiver.
The line of sight between the FM8 and the remote control
receiver in the DAC 8 DSD must not be interrupted by any
obstacles. Installing the DAC 8 DSD behind the glass doors of a
cabinet will also adversely affect the remote control system.
It is essential to prevent potentially interfering light (from
fluorescent lamps and energy-saving bulbs) falling directly on
the receiver, as this may markedly reduce the effective range of
the remote control system.
The front panel of the DAC 8 DSD incorporates a screen which
provides information about the DAC's operational state.
Additional information can also be called up on the screen when
desired.
Screen segments:

 Display area. The sampling frequency, the type of signal
and the set volume / balance (bargraph) is constantly
displayed here. If you alter any value - e.g. select a new
source - then the new value is briefly super-imposed here.
The meaning of the individual illuminated symbols is listed
in the table on the next page.

Segment  of the screen contains eight illuminated
symbols which display supplementary information relating
to the current mode of operation.

 The remote control receiver is located here.