Spot Cleaning - Dreame Rll42Sda Benutzerhandbuch

How to Use
EN

Spot Cleaning

When the robot is awaiting, press briefly the button
cleaning mode. In this mode, the robot cleans a square-shaped area of
1.5 x 1.5 meters around it and returns to its starting point once the spot
cleaning is completed.
Robot Restarting
If the robot stops responding or cannot be turned o , press and hold the
power button for 10 seconds to forcefully turn it o . Then, press and hold
the power button for 3 seconds to turn the robot on.
Use Mopping Function
to enable the spot
It is recommended that all floors are vacuumed at least three times before
the first mopping session to achieve a better cleaning e ect.
1. Dampen the mop pads and wring out excess water. Install and attach
the mop pads onto the mop pad holder in place. Lastly, install the mop
assembly onto the bottom of the robot.
2. Open the cover of the robot and take the water tank out. Fill the water
tank with clean water and then reinstall it.
Note:
· Do not use detergent or disinfectant.
· Do not fill the water tank with hot water as this may cause the water tank
to warp.