Seca 335 Bedienungsanleitung Und Garantieerklärung Seite 15

Use of differential display function
You can use this non calibratable function for example to measure the intake of milk when
breastfeeding or have Baby's increase in weight displayed since being last weighed. This
function can be used to store an individual weight value and then use that value to form
a difference - to detect the amount of milk ingested during breastfeeding, for example, or
to see how a particular baby's weight has increased since it was last weighed.
– To store the weight value, press the
STORE key for approx. 2 seconds after
the weighing operation is complete. The
ST0
indicator is faded in. The weight
value is now saved and will also remain
stored once the scale is switched off.
– With a subsequent weighing operation
it is then possible to switch the display
over to differential display, i.e. display of
current value less saved value, by briefly
pressing the STORE button.
When the differential display function is
activated, appears in the display.
– Briefly pressing the key again switches
the function off again.
Note:
If a new weight value is stored, the previous stored value will be overwritten.
If the differential display function is activated with no load on the scale, the stored value is
shown in the display as a negative value.
6. Cleaning
Clean the tray and the housing as required with a domestic cleaning agent or commercially-
available disinfectant. Follow the manufacturer's instructions.
7. What do I do if...
... no weight is displayed with a load on the scale?
– Is the scale switched on?
– Check the batteries.
0. 0 00
... does not appear before weighing?
– Press the Start key again - there must not be any load on the scale.
... one segment is illuminated permanently or not at all?
– That point has a fault. Inform your service agent.
... the display shows
– Battery power is dropping. Change the batteries in the next few days.
Model 335
?
15