Changing Attachments; Cleaning And Care Of The Unit; Technical Specifications - Beurer HT 50 Gebrauchsanweisung

Changing attachments

> Press the release button and pull the attachment (e.g. the round brush
[1]) off of the hot air styler.
> Line up the imprinted arrow on the other attachment (e.g. the thermal
brush [2]) with the release button.
> Push the attachment onto the hot air styler until you hear it click into
place.

7. Cleaning and care of the unit

Cleaning
Important
• Always pull the mains plug out of the socket before cleaning the device. Risk of electric shock!
• Ensure that no water gets inside the device! Risk of electric shock!
• Do not clean the device with highly flammable liquids! Risk of fire!
Note
• Your device is maintenance-free.
• Protect the device from dust, dirt and humidity.
• Do not clean the device in the dishwasher.
• Do not use any aggressive, caustic, abrasive, or corrosive cleaning products or hard brushes.
• The casing of the hot air styler and the attachments may be cleaned with a soft cloth dampened
with warm water.
• Before each use, remove any sucked-in fluff, dust or hair from the air outlet [4] and the air intake
filter [8] using an appropriately sized brush.
• If the round brush [1], the heated brush [2] and the nozzle [3] are very dirty, they must be removed
from the device and rinsed thoroughly under running water.
• Carefully dry the round brush [1], the heated brush [2] and the nozzle [3] after cleaning!
• The attachments may only be used again once they have fully dried off.

8. Technical specifications

Weight
Power supply
Power consumption
Safety class
Ambient conditions
Allowable temperature range
Subject to technical modifications.
Approx. 320 g
220 - 240 V ~, 50/60 Hz
1000 W
II
Only approved for indoor use
-10 to +40 °C
16