Problems - Melitta CI touch Bedienungsanleitung

Problems

12 Problems
If the actions listed below fail to rectify the problems or other problems not listed here
occur, contact our hotline (local rate).
The service number can be found on the lid of the water tank or in the Service area of our
Internet site.
Problem
Coffee only emerges as
drips from the spout.
Coffee not flowing.
Grinder is not grinding
any coffee beans.
Fill beans symbol flashes
although the bean con-
tainer is full.
Loud grinder noise.
Brewing unit cannot be
inserted after removing.
System error appears on
the display.
52
Cause
Grinding fineness too
fine.
Appliance soiled.
Appliance is covered
inside with limescale.
Water tank not filled or
inserted incorrectly.
Brewing unit clogged.
Beans do not drop into
ƒ
the grinder.
Tilt lever not vertical
ƒ
Coffee beans too oily.
ƒ
Foreign object in the
ƒ
grinder.
Beans do not drop into
the grinder. Insufficiently
ground beans in the
brewing chamber.
Foreign object in the
grinder.
Brewing unit is not
locked correctly.
Drive is not in the correct
position.
Software fault symbol.
Action
Set a coarser grinding fineness (see chap-
ƒ
ter 8.8).
Clean the brewing unit (see chapter 9.3).
ƒ
ƒ Run the cleaning programme (see sec-
tion 9.6).
Descale the appliance (see chapter 9.7).
ƒ
Fill the water tank and ensure it is posi-
ƒ
tioned correctly (see chapter 4.6).
Clean the brewing unit (see chapter 9.3).
ƒ
Tap lightly on the bean container.
ƒ
Clean the bean container.
ƒ
Move the tilt lever to the left or right.
ƒ
Use different coffee beans.
ƒ
Contact the hotline.
ƒ
Press the control button to dispense a cup.
ƒ
Contact the hotline.
ƒ
Check that the handle for the brewing unit
ƒ
locking mechanism is correctly engaged
(see chapter 9.3).
Press and hold the "my recipes" button.
ƒ
Also press the ON/OFF button. The appli-
ance initialises. Release the buttons again.
Switch the appliance off and on again (see
ƒ
chapter 4.1).
Contact the hotline.
ƒ