Using The Seat Heater - Waeco MagicComfort MSH300 Montage- Und Bedienungsanleitung

Using the seat heater

Electrical connection
The complete circuit diagram can be found in fig. h, page 5 and fig. i,
page 6.
A
NOTICE!
Ensure it has been securely fitted, particularly in the area of the
seat rails.
➤ Attach the switchbox to a suitable location in the vicinity of the dashboard
(fig. j, page 7).
➤ Find a suitable place for installing the seat heater switch.
If possible, use the blanking plugs provided for this purpose.
Ensure that there is enough room behind the panel for the installation of
the switch.
➤ Mark the switch cut-out using the template provided (fig. k, page 7).
➤ Cut out the marked area with an appropriate tool.
➤ Install the switch into the cut-out (fig. f, page 4).
➤ Install the ready-made wiring harness so that the cables cannot bend or
fray (fig. g, page 4).
7 Using the seat heater
I
NOTE
The seat heating logo (fig. l 1, page 7) also lights up when the
seat heating is switched on.
➤ Press the seat heater switch to turn on the seat heater:
– Press once: Level 3 (high heat output)
– Press twice: Level 2 (medium heat output)
– Press three times: Level 1 (low heat output)
✓ One, two or three LEDs (fig. l 2, page 7) on the switch light up in red.
➤ To switch the seat heating off: Press the switch until the LEDs (fig. l 2,
page 7) on the switch go out.
28
MagicComfort MSH300, MSH301
EN