Waeco MagicComfort MSH300 Montage- Und Bedienungsanleitung Seite 21

MagicComfort MSH300, MSH301
WARNING!
!
Inadequate supply cable connections could result in short circuits,
which could have as a consequence that:
 Cable fires occur
 The airbag is triggered
 Electronic control devices are damaged
 Electric functions fail (indicators, brake light, horn, ignition,
lights)
Please observe the following instructions:
 When working on the following cables, only use insulated cable lugs,
plugs and flat push-on receptacles:
– 30 (direct supply from positive battery terminal)
– 15 (connected positive terminal, behind the battery)
– 31 (return cable from the battery, earth)
Do not use terminal strips.
 The safest type of connection is to solder the ends of the cables together
and then insulate them.
Only use insulated cable terminals, plugs and flat sockets for releasable
connections. Do not use crimp terminals (cable connectors) or terminal
strips.
 Use a crimping tool (fig. 1 10, page 2) to connect the cables.
 When connecting to cable 31 (earth), screw the cable
– To the vehicle's earth bolt with a cable lug and a gear disc or
– To the sheet-metal bodywork with a cable lug and a self-tapping
screw.
Ensure that there is a good earth connection.
If you disconnect the negative terminal of the battery, all data stored in the
volatile memories will be lost.
 The following data must be set again, depending on the vehicle equip-
ment options:
– Radio code
– Vehicle clock
– Timer
– On-board computer
– Seat position
You can find instructions for making these settings in the appropriate
operating instructions.
EN
Safety and installation instructions
21