Waeco MagicComfort MSH300 Montage- Und Bedienungsanleitung Seite 22

Safety and installation instructions
Observe the following installation instructions:
 Secure the parts installed in the vehicle in such a way that they cannot
become loose under any circumstances (sudden braking, accidents) and
cause injuries to the occupants of the vehicle.
 To prevent damage, when drilling ensure that there is sufficient space on
the other side for the drill head to come out (fig. 2, page 3).
 Deburr all drill holes and treat them with a rust-protection agent.
Observe the following instructions when working with electrical parts:
 When testing the voltage in electrical cables, only use a diode test lamp
(fig. 1 8, page 2) or a voltmeter (fig. 1 9, page 2).
Test lamps with an illuminant (fig. 1 12, page 2) take up voltages which
are too high and which can damage the vehicle's electronic system.
 When making electrical connections (fig. 3, page 3), ensure that
– They are not kinked or twisted
– They do not rub on edges
– They are not laid in sharp-edged ducts without protection.
 Insulate all connections.
 Secure the cables against mechanical wear with cable binders or insulat-
ing tape, for example to existing cables.
Observe the following instructions when using the seat heater:
 Do not place any sharp or heavy objects on the seat, as the seat heater
could otherwise be damaged.
 Persons with an impaired sensitivity to heat should only operate the seat
heater at level 1.
 Do not place any heat insulating objects, such as blankets or coats, on the
seat when the seat heater is switched on.
 The seat heater can be damaged by fluids spilt on the seat.
 Never switch the seat heater on when it is wet.
22
MagicComfort MSH300, MSH301
EN