Power Supply - Audisse shokunin Kurzanleitung

POWER SUPPLY

AC OPERATION
1. Before plugging the AC power cord into the AC mains power socket, be sure the
voltage is correct.
2. Never use the AC power cord in rainy or moist conditions to prevent short circuit or
moist from entering the radio. Under those conditions only use battery power and
keep all rubber covers well closed.
NOTE:
In order to disconnect the radio from the AC mains power completely, the AC power
cord should be removed from the AC mains power socket completely and it shall remain
readily operable and should not be obstructed during intended use.
In case of malfunction due to electrostatic discharge or fast transient (burst), remove
the AC power cord from AC mains power socket and reconnect the power supply after
approximately one minute.
LITHIUM BATTERY OPERATION AND CHARGING
NOTE ON FIRST USE : BEFORE OPERATING THE AUDISSE SHOKUNIN FOR THE
FIRST TIME ALWAYS FIRST FULLY CHARGE THE LITHIUM BATTERY.
The Audisse Shokunin can be operated by the built-in Lithium battery. During operation
on battery power the approximate power level of the battery is displayed by the 4
segments battery icon in the top right corner of the LCD display. When the battery power
level is very low, the "empty" icon will start flashing. Under this condition, the battery
should be recharged as soon as possible to continue normal operation of the Audisse
Shokunin.
Charging time from empty to full battery is approximately 6-7 hours (at room temperature
with the radio in Standby mode). The Audisse Shokunin can be charged in Standby
mode as well as in On mode while playing music. While playing music the charging
time will be longer than in Standby mode. When charging is in process the battery icon
segments will animate.
The Audisse Shokunin, for additional safety, will not start the charging process
when the battery is already full or nearly full.
GB
6