Presetting Radiostations - Audisse shokunin Kurzanleitung

To find more FM stations press the Tuning/Seek/Select control to repeat the scan
operation. To scan down in frequency, rotate the Tuning/Seek/Select control in a anti-
clockwise direction first and then press the control. Your radio will scan down the FM
band from the currently displayed frequency and will stop scanning when it finds a signal
of sufficient strength.
When the end of the waveband is reached Audisse Shokunin will recommence tuning
from the opposite end of the waveband.
Use the Volume control to adjust the sound level as needed.

PRESETTING RADIOSTATIONS

There are 40 memorypresets. They are used in the same way for each operating mode.
The Audisse Shokunin has the unique function of Preset + and Preset –
This enables you to quickly zap through your whole preset list.
When performing a Factory Reset the whole Preset memory of the radio will be emptied.
To store radio stations into 40 memory presets by using Preset button.
Press the Power button to switch on Audisse Shokunin.
Tune to the required radio station as previously described.
To store the station as a preset station, press and hold the Preset button until the
display shows a preset menu 'Save to Preset'.
Rotate the Tuning/Seek/Select control to the desired preset number until it is
highlighted. Press the Tuning/Seek/Select control to confirm and the display shows
'Preset Stored'. The station will be stored under the chosen preset button. Repeat this
procedure as needed for the remaining presets.
Stations which are already stored in the presets may be over written by following the
above procedure.
Note: The radio station presets are retained in memory when the sound system is
switched off and disconnected from the mains supply.
25