Audisse shokunin Kurzanleitung Seite 15

If your network is configured without an encryption key, the screen should say
'Connecting...', and then 'Setup wizard completed'. Press the Tuning/Seek/Select
control to exit the setup wizard and show the Main menu. If this is the case then you
have successfully connected Audisse Shokunin to your network.
If the screen displays 'Key:', it is because the network is using one of the encryption
systems: Wired Equivalent Privacy (WEP) or WiFi Protected Access (WPA). You
will need to enter the correct WEP or WPA key into the sound system to allow it to
communicate with your wireless network. If you do not have the WEP or WPA key, then
you should obtain it from the person who set up your network. Some wireless routers
may come with an encryption key already set up by the supplier, in which case you
should refer to the documentation provided with it. WPA is used here to also include
WPA2.
WEP keys are 10 or 26 characters long (using 0 - 9, and A - F). Some wireless routers
can also use pass-phrases for WEP but these are not supported by the sound system.
WPA keys are usually set up using a pass-phrase of between 8 and 63 characters.
Audisse Shokunin accepts pass-phrases for WPA keys.
To enter the WEP or WPA key, characters are selected and entered using the Tuning/
Seek/Select control. As you rotate the control, the highlight scrolls through the available
characters as well as the three controls on the right. The character currently highlighted
will be entered when you press the Tuning/Seek/Select control.
Do this as needed until the complete key has been entered. Remember, WEP keys only
use the numbers 0-9 and letters A-F. WPA keys are sensitive to upper and lower case
characters. You must enter the key exactly or the sound system will not connect to the
network.
GB
14