Azdome M01 Pro Bedienungsanleitung Seite 5

Plug the rear camera cable into
the AV INput socket on the front
camera.
➀
➂
Install Rear Camera
9.1. Choose a flat and central location near the number plate lamp
at the rear of your vehicle to mount the camera.
9.2. Attach tape to the camera bracket to hold it in position while
installing it. Then, drill two small holes: one for the first screw and the
second to run the reverse camera cable through.
EN-05
Conect the red wire of
the camera to the
reversing light.
➁
9.3. Use a screwdriver to secure the first screw, but leave it loose
enough so that you can adjust the camera as needed.
9.4. Thread the camera wire through the hole that you drilled and
check the installation position.
9.5. Mark the location that is suitable for the second screw and drill
a small hole for it.
9.6. Securely tighten both screws to fix the camera in place.
9.7. Once the installation is completed, connect the rear plug to the
rear camera interface on the recorder. Then, connect the red reverse
line on the extension line of the rear camera to the positive pole on
the reverse light.
EN-06