Transmission Fluid Exchange - Autool Atf702 Bedienungsanleitung

●
●
●
●
Transmission
●
fluid exchange
●
●
Turn the left valve to the "CLEANING" position, and the right valve to the
"EXTRACTING" position.
Turn on the power switch, and at this point, the cleaning fluid will be
drawn into the transmission.
Once the cleaning fluid has been fully injected, remove the transparent
short hose, turn off the machine's power switch, and leave the valves in
the same position.
Start the vehicle's engine (the machine's power does not need to be
turned on during flushing). At this point, the machine is in circulating flush-
ing mode, and the flow of oil can be observed through the new and old oil
sight glasses. During the flushing process, manually shift through each
gear and hold for 10–20 seconds. The flushing takes about 10 minutes,
after which the engine can be turned off.
Turn the left valve to the "EXCHANGING" position and the right valve to
the "EXCHANGING" position. Switch on the machine's power, and new
oil will begin to be filled into the transmission. When oil flow is visible in
the new oil sight glass, start the vehicle's engine to begin the automatic

transmission fluid exchange.

During the oil exchange process, observe the new oil sight glass and the
old oil sight glass. If the flow rate of the new oil is slower than that of the
old oil, adjust the manual valve on the return hose to reduce the old oil
flow and balance the flow rates of both new and old oil.
During the exchange process, shift through each gear and hold for 10~20
seconds.
9