Replacing Brake Fluid - Autool Ast603 Bedienungsanleitung

Replacing
brake fluid
● At this point, the brake fluid bleeder has completed the purging
process and is ready for use.
Warning
Changing brake fluid must strictly adhere to the safety guide-
lines and specifications provided.
Before starting work, pay attention to the vehicle manufactur-
er's instructions regarding the maximum filling pressure and
any special operational guidelines.
As a general rule, the guidelines and criteria for purging brake
equipment provided by the manufacturer for each vehicle
model are always applicable.
If the manufacturer's guidelines and criteria for purging brake
equipment do not specify a particular working pressure, adjust
the pressure using the adjustment knob to 1.6-2.0 bar. For
specific working pressures, use the adjustment knob as
needed.
●
Install the appropriate adapter on the vehicle's brake fluid
reservoir.
●
Connect the filling hose quick-connect interface to the installed
adapter.
Turn on the brake fluid bleeder and switch on the power.
●
●
Press and hold the "Start" button until the pressure reaches at
least 1.0 bar. At this point, use the adjustment knob to set the
working pressure to the desired value (Pressure Building
Step).
Warning
If the pressure is successfully established, release the "Start"
button; the brake fluid bleeder should continue operating. If the
pressure is not established, release the "Start" button; the
brake fluid bleeder will stop immediately.
12