Step 3: Settings; Turning On The Unit; Configuring Initial Settings With Setup Wizard - Sony IPELA NSR-1000-Serie Installationsanleitung

Step 3: Settings

This section provides information on how to turn on the
unit, and general explanations on how to register
cameras and other devices.

Turning On the Unit

When you press the power switch on the front or rear of
the unit, the unit will turn on. When an optional NSRE-
S200 is connected, wait until the NSRE-S200 has turned
on before turning on this unit.
Caution
Take the inrush current into consideration when
configuring power connections for systems that include
multiple NSR units or an NSRE-S200 unit. For details
on the inrush current, see "Reference Data for
Installation" (page 10).
Front power switch
POWER
Rear power switch
The power LED on the front panel is lit green when the
unit is turned on.
When you turn on the unit for the first time, the Setup
Wizard starts automatically.
Continue to the following section, "Configuring Initial
Settings with Setup Wizard."
Notes
• The fan noise may be loud for about 2 seconds after
turning on the unit. This is not a malfunction.
• If the unit was shut down through system operations,
press the power button on the front panel or the power
switch on the rear panel to turn on the unit.
• If a forced shutdown was performed previously, the
unit may take longer to start up.
20
Step 3: Settings
NETWORK 1 2 3 HDD 1 2 3 4 STATUS 1 2 3 4 ERROR
To turn off the unit
After logging on to NSR, click
"Main" screen, and select [Shutdown] from the menu
that appears.
Note
Normally, the unit turns off after a few minutes. If the
unit does not turn off after a few minutes, force
shutdown by pressing the power switch on the rear panel
of the unit in the 1 position for at least 5 seconds.
Configuring Initial Settings with
Setup Wizard
This section explains the general flow of the Setup
Wizard. For further details on settings, refer to
"Changing Initial Settings with the Setup Menu" in the
User's Guide (PDF).
The Setup Wizard starts automatically when you turn on
the unit for the first time. You can configure the same
settings afterward by accessing the logon screen, the
Administration Menu, and then the Setup Menu.
For details, refer to "To access the Setup Menu from the
logon screen" (page 24).
When you turn on the unit, the Setup Wizard starts after
the following screen appears.
↓
Click [Next].
↓
at the top of the