I/O Port - Sony IPELA NSR-1000-Serie Installationsanleitung

I/O Port

Pin Assignment of I/O Port
Sensor In
Pin NO. SENSOR IN
1 3.3 v
2 IN_8 –
3 IN_8 +
4 IN_7 –
5 IN_7 +
6 IN_6 –
7 IN_6 +
8 IN_5 –
9 IN_5 +
10 IN_4 –
11 IN_4 +
12 IN_3 –
13 IN_3 +
14 IN_2 –
15 IN_2 +
16 IN_1 –
17 IN_1 +
18 GND
Alarm Out
Pin NO. ALARM OUT
1 GND
2 OUT_8 –
3 OUT_8 +
4 OUT_7 –
5 OUT_7 +
6 OUT_6 –
7 OUT_6 +
8 OUT_5 –
9 OUT_5 +
10 OUT_4 –
11 OUT_4 +
12 OUT_3 –
13 OUT_3 +
14 OUT_2 –
15 OUT_2 +
16 OUT_1 –
17 OUT_1 +
18 GND
38
Miscellaneous
RS-422/485
Pin NO. RS-422
19 TX–
20 TX+
21 RX–
22 RX+
Using the I/O Receptacle
Insert a small slotted screwdriver into the upper or lower
slot of the hole you want to connect a wire to (AWG No.
26 to 20). Hold down the screwdriver and insert the wire,
then release the screwdriver.
Caution
Do not use excessive force when inserting the
screwdriver into the slot. Doing so may result in
damage.
1
2
Repeat this procedure to connect all required wires.
Wiring Diagram 1 for Sensor Input
Inside of this unit Outside
3, 5, 7, 9, 11,
13, 15, 17 pin
(SENSOR IN+)
Sensor device
2.35 kΩ
output:
DC 3.3 V to 24V
2, 4, 6, 8, 10,
12, 14, 16 pin
(SENSOR IN–)
RS-485
TX–
TX+
3