Initial Start-Up - AXENT E82.1000.0000.2 Bedienungsanleitung

INITIAL START-UP

I N ITIAL START- U P O F TH E R E M OTE CO NTRO L
By inserting the batteries the remote control is activated. As soon as you sit on the shower toilet unit the device can be used either with
the remote control or the control panel.
The remote control turns of after 30 sec. should the LED blink on « Rear and Lady Wash » the batteries need to be changed.
Further instruction can be found at « Replacing the Batteries »
ACTIVATE TH E S H OWE R TO I LET
After installation of the shower toilet the main plug can be connected. The initial start-up will be done automatically by the device. The
blue power LED will then turn on.
Stop Rear Wash Lady Wash
By pressing the « S top » button for 3 sec. The device can be turned off or on. Stop (3s)
U S E R I D E NTI FI CATI O N
A sticker on the toilet ring marks the area where the user is identified. Should it have been removed during installation, please find on the
image below where the area is to be found.
The activated carbon filter turns on as soon as seated on the shower toilet. At the same time the device cleans
automatically the nozzles before and after each use. After leaving, the actived carbon filter runs for another 60 sec. and then turns of
automatically.
AUTO MATI C C LOS I N G O F S E AT AN D LI D
The installed damper closes the seat and toilet lid slowly and silently. It opens manually as any other toilet.
DO NOT PUSH DOWN THE LID OR TOILET SEAT MANUALLY. THIS COULD HARM THE INSTALLED DAMPER.
7