DJI MATRICE 300 RTK Kurzanleitung Seite 8

Mounting the Gimbal and Camera
1 1
Press the Gimbal
Detachment button to
remove the cover.
After installation, make sure that the gimbal lock is locked in place.
●
Make sure to press down the Gimbal Detachment button when rotating the gimbal lock to remove the gimbal and camera. The gimbal lock
●
should be fully rotated when removing the gimbal for the next installation.
Mounting the Intelligent Flight Batteries / Checking the Battery Level
Insert a pair of batteries.
Press the battery level button once to check the battery level.
Turning On the Aircraft
Turn on / off: Press the power button on the aircraft, within 3 seconds press again and hold to
turn on / off the aircraft, with the power indicator solid on.
Link: Press and hold the aircraft's power button at least five seconds to link the aircraft and
Smart Controller. The power indicator will blink during linking.
5. Flight
Before taking off, make sure the Aircraft Status Bar in the DJI Pilot app displays
"Ready to Go (GPS)" or "Ready to Go (RTK)".
Manual Takeoff / Landing
Combination Stick Command to start / stop
the motors.
Slowly push the left stick up to take off.
(Mode 2)
2
Align the white and red
dots and insert the gimbal.
3
Rotate the gimbal lock to the
locked position.
OR
Slowly push the left stick down until the aircraft
lands. Hold for a few seconds to stop the
motors.
High
Low
Ready to Go (GPS)
7