DJI MATRICE 300 RTK Kurzanleitung Seite 6

3. Preparing the Smart Controller
Mounting the WB37 Intelligent Battery
Press and hold the battery release button.
1
Insert the Intelligent Battery into the battery
2
compartment. Make sure the bottom of the battery is
aligned to the marking line in the compartment.
Push the battery to the bottom.
3
1
3
2
• To remove the Intelligent Battery, press and hold the battery release button, then push the battery upward.
• Refer to the BS60 Intelligent Battery Station User Guide for Intelligent Battery charging details.
Checking the Battery Level and Turning On
Check the internal battery level according to the Battery Level LEDs.
Press the power button once to check it while turned off.
Press the power button once, press again and hold for a few seconds to
turn on / off the Smart Controller.
Please refer to the user manual for more details about checking the internal and external battery levels.
When using external WB37 Intelligent Battery, it is still necessary to make sure that the internal battery has some power.
Otherwise, the Smart Controller cannot be turned on.
Adjusting the Antennas
Lift the antennas and adjust them. The strength of the Smart Controller signal is affected
by the position of the antennas. When the angle between the antennas and the back of the
Smart Controller is 80° or 180°, the connection between the Smart Controller and aircraft can
reach its optimal performance.
Optimal Transmission Zone
Try to keep the aircraft inside the optimal transmission zone. If the signal is weak, adjust the antennas or fly the aircraft closer.
• Avoid using wireless devices that use the same frequency bands as the Smart Controller.
• In real operation, the DJI Pilot app will issue a prompt to warn that the transmission signal is weak, and please adjust the antennas to
ensure that the aircraft is back to the optimal transmission range.
3
2
Mounting the 4G Dongle and
SIM Card
• Only use a DJI-approved dongle.
• The dongle and SIM card enable the Smart Controller to
access 4G network. Make sure to deploy these correctly,
otherwise, network access will not be available.
• The dongle and SIM card are excluded.
Remove the dongle
compartment cover.
Insert the dongle into the USB
port with the SIM card inserted
into the dongle.
Reattach the cover firmly.
80°
Low High
5