Problem: No Sound - Helix Conductor Bedienungsanleitung

Error code 6:
Cause:
Solution: Connect your DSP / DSP amplifier to a PC and start the latest DSP PC-Tool software.
Fehlercode 7:
Cause:
Solution: Fix the cause of the Protection Mode. Further information can be found in the respec-
Error code 8:
Cause:
Solution: Check all plug connections and use the latest version of the DSP PC-Tool.
Problem: CONDUCTOR does not turn on
Possible cause: Faulty plug connection.
Solution: Check the tight fit of the plug connector.
Problem: LED lighting off
Possible cause: The "LED Dimming" setting is configured to "LEDs off", which will turn off the illumination after 8 sec-
onds of inactivity. If this is not the case, check the wiring.
Solution: Enable the LED feedback rendition as described on page 36 in point 4.1.5 "LED Dimming".
Problem: No sound
Possible cause: Volume set too low; mute activated; incorrect input source.
Solution: Check volume level of Volumes 1 - 4 and whether they have been activated in the DSP PC-Tool;
disable mute (muting is signalled by a single rotating LED / demuting: The knob must be pressed for
a long time or turned when the volume menu is selected); change input source.
Problem: No connection with compatible device possible
Possible cause: Transmission problem to the DSP; incompatible software versions.
Solution: Check the tight fit of the CONDUCTOR plug connector; update the CONDUCTOR and ACO software
with the current DSP PC-Tool.
DSP in the signal processor / DSP amplifier is not started.
Update the software of the DSP with the latest DSP PC-Tool.
The connected device is in Protection Mode.
tive manual of the DSP / DSP amplifier under the point "Satuts LED".
An unknown error has occurred.
en
41